Opher

iTrader: (1)

Clearing out a few odds n ends from the 3rd gen collection. Tired of moving the ****, tired of storing it. Im going to finish the convertible and call it a day.

Complete Non A/C dash setup. I mean everything. The exterior blower motor housing, the inside heater box, the correct non ac dash hull, the left and right fresh air vents w/ cables. non ac heater controls with all the cables and connections. The dash hull has some minor cracks, they can be repaired, I can repair them for you if you wish for some extra $$. This came out of an 85, I took it out myself. I planned on using it in something else and I wanted every piece--$350obo

"113" Vette aluminum heads. Have like no miles on them. They came off a ZZ crate motor. I had them decked and checked. They are ready to run, super clean--$650obo

Vette TPI intake runners for an 89-91. These are the rough cast finish runners, they were also used on some late production 92 F bodies. These have been walnut shelled and clear coated. They are perfect, no dings, dents--$150obo

Vette TPI lower intake base. This thing has been walnut shelled and clear coated, its mint--$150obo

Vette TPI valve covers. All original, need to be refinished. These are factory magnesium valve covers. Hard to find--$100obo

Complete Dual snorkel air cleaner setup off a L69 HO car. I have the air cleaner housing, the left side duct work, the right side duct work, left side plastic air intake housing and right side plastic air intake housing. Its pretty complete. $150obo, next stop ebay for this setup.

N10 dual cat convertor setup off an 89-92 F body. These added 10hp to a stock car. The "AIR" tube is busted off at the rear, but other than that its in great shape--$75

92 L98 Longblock out of a 92Z. Had around 100k, ran great. Its a later production motor as it has the black valve covers instead of silver ones. Its a complete long block, valve covers, balancer, oil cooler. $300

87 Camaro SC Roller, comes with the motor and trans, super super super clean. The paint is alright, but there is no rust. $1000

The parts are located in Lake Villa, IL 60046 at my shop.

codeysabatini

iTrader: (14)

Can I get some pics of the Roller to codeysabatini@hotmail.com
Thanks

IROCZ28KevinZ

iTrader: (2)

still have the N10 dual cat setup? does it still have the y pipe that goes up to the manifolds? any shance of getting a couple pics? thanks

Opher

iTrader: (1)

this can be deleted, its all gone