[AZ] Edelbrock 90 mm TB & Edelbrock low profile elbow
#1
Member
Thread Starter
iTrader: (1)
Join Date: Jul 2009
Location: PHX
Posts: 376
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91' RS
Engine: 310 C.I.D. + n2o
Transmission: T-5
Axle/Gears: built 10 bolt 3.73's
Edelbrock 90 mm TB & Edelbrock low profile elbow
Everything is new never used just been sitting on the shelf for a while
Throttle body $240 +shipping----SOLD!
Elbow $150+shipping
both together $360+shipping
Throttle body $240 +shipping----SOLD!
Elbow $150+shipping
both together $360+shipping
Last edited by mr305; 03-04-2013 at 07:42 PM.
#5
Re: Edelbrock 90 mm TB & Edelbrock low profile elbow
I hope you don't mind and its been a while since this was posted but... do you all think this set up will work with the professional product hurricane intake manifold on a 87 iroc? I mean TB and the edelbrock TB? if so what is required (if anything) to have this TB on a TPI car? any mods that need to be done for this???
#6
Member
Thread Starter
iTrader: (1)
Join Date: Jul 2009
Location: PHX
Posts: 376
Likes: 0
Received 0 Likes
on
0 Posts
Car: 91' RS
Engine: 310 C.I.D. + n2o
Transmission: T-5
Axle/Gears: built 10 bolt 3.73's
Re: Edelbrock 90 mm TB & Edelbrock low profile elbow
Elbow will work since it has a 4150 flange
Minimal wiring would be needed
Minimal wiring would be needed
Thread
Thread Starter
Forum
Replies
Last Post
toronto formula
Engine/Drivetrain/Suspension Parts for Sale
3
09-10-2015 07:31 AM