Mechanical Clutch Linkage
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2004
Location: Bloomington,IL
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Trans Am
Engine: Chevrolet 355
Transmission: Borg Warner W.C. manual cog
Axle/Gears: B W 9-bolt 3.45 Limited Slip
Mechanical Clutch Linkage
I'm doing the auto to T-5 swap and am looking for the complete mechanical clutch linkage ( 82-3? ) from the pedal to the throwout fork.
#2
Re: Mechanical Clutch Linkage
did you have any luck with your set up? my father in-law just bought an 82 camaro with a t-5 in it with mechanical linkage and it is a real hack job and i have to fix it ,its wearing out the pedals. what were you able to do? i would like to find the stock set up for it but cant find any info either.
#3
Junior Member
Thread Starter
iTrader: (1)
Join Date: Aug 2004
Location: Bloomington,IL
Posts: 48
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Trans Am
Engine: Chevrolet 355
Transmission: Borg Warner W.C. manual cog
Axle/Gears: B W 9-bolt 3.45 Limited Slip
Re: Mechanical Clutch Linkage
I could not find any of the mechanical setup in good condition so i opted to go with the hydraulic setup which was quite easy ,except for the bleeding of the slave cylinder,as i went with an aftermarket instead of the pre bled GM, but as long as you "reverse bleed" it , no problem. Maybe you should go with the hydraulic. It works good and less moving parts. If you have any problems feel free to e-mail me if you wish.
#4
Re: Mechanical Clutch Linkage
thanks abunch for your reply i will talk it over with my father in-law, but i know his answer already . my other question though is did 82 come with mech. or hydr.? i do know 83 are hydr. thx. again
Thread
Thread Starter
Forum
Replies
Last Post
Night rider327
Engine/Drivetrain/Suspension Parts for Sale
0
09-02-2015 04:17 AM