Rattles with a Hooker cat-back
#1
Member
Thread Starter
iTrader: (3)
Join Date: Jul 1999
Location: Russellville, Al USA
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
Rattles with a Hooker cat-back
Has anyone else had this problem? It looks like it is too low coming over the axle and barely touching the panhardrod. Has anyone else added another hanger, or anything?
#2
Supreme Member
iTrader: (8)
Join Date: Jan 2000
Location: Macedonia ,OH
Posts: 3,968
Likes: 0
Received 1 Like
on
1 Post
Car: Formula
Engine: 6.0 LSX
Transmission: 4L60E
Axle/Gears: 9 Bolt 3:27
I had teh same problem with my edelbrock i had to place a spacer under the Lhnger in the rubber mount so it was like 1/4 up on the axle or track bar.
#4
Member
Thread Starter
iTrader: (3)
Join Date: Jul 1999
Location: Russellville, Al USA
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
Yeah it's pretty bad with the car in gear and my foot on the brake just ideling. But going down the road or just in neutral it's quiet. I wish I knew of another spot to put a hanger to keep it up a little higher.
#5
Supreme Member
Join Date: Jul 1999
Location: Atlanta, GA, US of A
Posts: 1,366
Likes: 0
Received 0 Likes
on
0 Posts
Car: 94 Z28
Engine: LT1 w/ headers, catback, CAI, tune
Transmission: 4L60E
Axle/Gears: 3.23s
Just monkey with the hangers a bit to lift the pipe up a little. Proper over-axle/panhard rod clearance is a concern w/ basically every aftermarket exhaust. No rattles on my Hooker system after careful setup.
------------------
Ray87Z
-Vortec headed 350.
86 IROC w/ a cammed 305 TPI.
Formerly Ray86IROC.
www.inter-scape.com/Ray
------------------
Ray87Z
-Vortec headed 350.
86 IROC w/ a cammed 305 TPI.
Formerly Ray86IROC.
www.inter-scape.com/Ray
#6
I think I may have found the problem with mine...one of the hangers is too long on the top part and the excess is causing the noise so I just to cut that extra piece off I guess
Thread
Thread Starter
Forum
Replies
Last Post
no green
Engine/Drivetrain/Suspension Parts for Sale
11
01-09-2016 09:22 PM