Anybody fab up these panels
07-25-2005, 10:09 AM
#1
Anybody fab up these panels
Ran across this car at a couple shows this summer. It's not a full tube frame car, basically front and rear clips. Anyways, I love the sheetmetal panels they made for the inner fenders...anybody ever done this on a non-tube frame car? I know you would have to make provisions for the strut tower caps but I still think it could look good if a fellow knew what he was doing. Sorry for the crappy pic quality.
07-26-2005, 08:59 PM
#2
Supreme Member
Join Date: Dec 2002
Location: Central FL
Posts: 2,564
Likes: 0
Received 1 Like
on
1 Post
Car: 91 Camaro
Engine: 3.1...not hardly stock
Transmission: 700r4....not stock either
Axle/Gears: 3.73
i have started on some fiberglass ones real similar to that!! its a non-tube chassis car and they will go over the top of the strut caps.
07-27-2005, 01:53 PM
#4
Supreme Member
Join Date: Dec 2002
Location: Central FL
Posts: 2,564
Likes: 0
Received 1 Like
on
1 Post
Car: 91 Camaro
Engine: 3.1...not hardly stock
Transmission: 700r4....not stock either
Axle/Gears: 3.73
i don't have any yet. but, i can snap a few. all that i have so far is a wire mesh that i'm using for the frame structure. if i have time/think about it, i'll set them in the engine bay and take a couple of pictures.
Thread
Thread Starter
Forum
Replies
Last Post
tmork454
Transmissions and Drivetrain
0
09-29-2015 06:33 PM
formula00ra
Interior Parts Wanted
1
09-28-2015 11:50 AM