decided to cut the floor
#1
Member
Thread Starter
Join Date: Aug 2007
Location: Goldsboro, NC
Posts: 200
Likes: 0
Received 0 Likes
on
0 Posts
Car: 82 camaro sc
Engine: 355 SBC
Transmission: T56
Axle/Gears: ford 8.8 3.73
decided to cut the floor
i had a hole in my floor for my custom tq arm setup that i wanted to box in. i decided to competely cut out the rear floor and raise it up to make room. im hoping to re run the exhaust down the tunnel under the drive shaft then tuck the mufflers in the new space...we will see how it goes
#2
Supreme Member
iTrader: (24)
Join Date: Jun 2005
Location: NC
Posts: 7,899
Likes: 0
Received 90 Likes
on
54 Posts
Car: 92 Firebird
Engine: Supercharged 6.0
Transmission: T56
Axle/Gears: 8.8 3.73
Re: decided to cut the floor
Seems aweful intrusive just to fit some mufflers in. That type of floor is better suited for a backhalf
#3
Member
Thread Starter
Join Date: Aug 2007
Location: Goldsboro, NC
Posts: 200
Likes: 0
Received 0 Likes
on
0 Posts
Car: 82 camaro sc
Engine: 355 SBC
Transmission: T56
Axle/Gears: ford 8.8 3.73
Re: decided to cut the floor
its not just for mufflers, i also had to make room for my new tq arm and tq arm x-member
#5
Member
Join Date: Feb 2007
Location: Toronto
Posts: 105
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Trans Am
Re: decided to cut the floor
Nice. My rear seat pans are pretty screwed up with rust so I was thinking about something similar to this for a rear seat delete.
Thanks for posting these pics man. Gives me some ideas.
Thanks for posting these pics man. Gives me some ideas.
#7
Member
Thread Starter
Join Date: Aug 2007
Location: Goldsboro, NC
Posts: 200
Likes: 0
Received 0 Likes
on
0 Posts
Car: 82 camaro sc
Engine: 355 SBC
Transmission: T56
Axle/Gears: ford 8.8 3.73
Thread
Thread Starter
Forum
Replies
Last Post
snowflake
Tech / General Engine
7
10-19-2015 10:24 PM