Window question...... need help
#1
Member
Thread Starter
iTrader: (6)
Join Date: May 2003
Location: Utah
Posts: 225
Likes: 0
Received 0 Likes
on
0 Posts
Car: 00' rcsb
Engine: Little boosted 5.3
Transmission: 4l80e
Window question...... need help
I am swaping the power doors in my camaro. the problem is my new door has the window rolled down and there is currently no motor or wirirng harness in the door. so i have no power to roll the winodw up. is there any way i can get the window up with no power? is there any way to get it up at all?
thanks
Colt
thanks
Colt
#2
Junior Member
Join Date: Jun 2007
Location: Wisconsin
Posts: 86
Likes: 0
Received 0 Likes
on
0 Posts
Car: Divorce stole it
Engine: Divorce stole it
Transmission: Divorce stole it
Axle/Gears: Divorce stole it
Re: Window question...... need help
The only thing I can think of is manually going in and turning the gears by hand. But I am a little confused, is the window supposed to be manual or power. Either way, without out the handcrank or motor there is not much besides what I can up with, but if someone else has a better idea lets hear it cause ive seen enough threads that ask help.
#3
Member
Thread Starter
iTrader: (6)
Join Date: May 2003
Location: Utah
Posts: 225
Likes: 0
Received 0 Likes
on
0 Posts
Car: 00' rcsb
Engine: Little boosted 5.3
Transmission: 4l80e
Re: Window question...... need help
the window is power, it has the motor connected to gear and armature and is still rivited in the window. i need to know if there is a way to get the window up with the motor connected to the armature and door without any power to it
#4
Supreme Member
iTrader: (2)
Join Date: Dec 2005
Location: Beaufort South Carolina
Posts: 1,739
Likes: 0
Received 4 Likes
on
4 Posts
Car: 1983 Camaro Z/28
Engine: LU5 305 CFI
Transmission: 700R4
Axle/Gears: J65/G80/G92-3.23
Re: Window question...... need help
Did the car have power windows to start with?If so then just connect the motor harness plug(harness doesn't have to be in the door to do it).If not then apply power to the connector on the motor.Use a set of jumper cables from the battery and then smaller,12ga for example,wire to connect.It may take 2 tries to get polarity correct for the motor to move the window up.
Thread
Thread Starter
Forum
Replies
Last Post