Idea? for camaro panel will it work out
#1
Idea? for camaro panel will it work out
Ok I swapped a 350 in my SC and now in need of gauge panel (got 5 in Tach/Speedo, 2-2 1/16 volt/fuel)
So I am in the process of making a panel out of 1/4 plexiglass ok now for the problem
I have an idea of masking off 2 turn arrows, high beam indicator, and brake. Paint the front of the plexi flat black or hammertone for factory look. Then peel back all the indicators and poss use tape, watercolor, translucent paint on the back.
Is there something I can paint the back with that will allow light through or anyway of mounting a lighting fixture to the back?
If not I will just go the LED turns/brake route
So I am in the process of making a panel out of 1/4 plexiglass ok now for the problem
I have an idea of masking off 2 turn arrows, high beam indicator, and brake. Paint the front of the plexi flat black or hammertone for factory look. Then peel back all the indicators and poss use tape, watercolor, translucent paint on the back.
Is there something I can paint the back with that will allow light through or anyway of mounting a lighting fixture to the back?
If not I will just go the LED turns/brake route
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
15
12-29-2023 08:23 AM
db057
TBI
10
08-11-2015 10:11 PM
IROCZDAVE (88-L98)
Interior Parts for Sale
0
08-06-2015 03:51 PM