A Pillar insulation
#1
Junior Member
Thread Starter
Join Date: Aug 2011
Location: Las Vegas
Posts: 26
Likes: 0
Received 1 Like
on
1 Post
Car: 2016 Camaro SS/1988 Firebird GTA
Engine: 5.7 L
Transmission: 700 r4
A Pillar insulation
I just bought used A pillars from Hawks because the pillars in my 88 GTA were falling down because the part that holds the t-looking clips had all broken off. I was hoping my replacements would have better seals than the 26 year old ones in mine. They weren't. Anyone have an idea on where to get this seal or what to use to replace the seals? Any help is much appreciated.
#2
Supreme Member
iTrader: (1)
Join Date: Aug 2008
Location: Short Summer, VT
Posts: 1,485
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1985 Trans Am T-Top
Engine: 305 TPI
Transmission: T-5 5 Speed
Axle/Gears: 3.42 posi 1LE 10 bolt
Re: A Pillar insulation
Assuming you mean a pillar TRIM, the stick on weatherstrip tape works great.
The factory just lightly glued a strip of rubber to the edge, it isn't specially shaped or anything. It's only purpose is to keep stuff from getting in there with the windows open.
The factory just lightly glued a strip of rubber to the edge, it isn't specially shaped or anything. It's only purpose is to keep stuff from getting in there with the windows open.
Thread
Thread Starter
Forum
Replies
Last Post
1Aauto
Sponsored Vendors
0
08-24-2015 03:40 PM