will a 3rd gen 2.8 v6 iat sensor work on a lt1?
07-29-2009, 11:48 PM
#1
Banned
Thread Starter
iTrader: (1)
Join Date: Feb 2007
Posts: 386
Likes: 0
Received 0 Likes
on
0 Posts
will a 3rd gen 2.8 v6 iat sensor work on a lt1?
i made a highflow lid out of a 2.8 v6 camaro lid and its got the intake air temp sensor that screws into the lid itself,and to make a long story short im going to the track and im gonna test my stock lid vs the high flow lid but i glued my lt1 iat sensor into the stock lid so i cant remove it,so can i just use the iat sensor that came in the v6(now high flow)lid?are they basically the same?,they both have the same plug style and the iat wire snaps into the sensor fine just wanna make sure it aint gonna throw a code or kill performance,thanks in advance,joe, here's a couple pics of the(v6) highflow lid & iat sensor:
Last edited by bmfIROC-Z; 07-30-2009 at 12:10 AM.
07-30-2009, 07:18 PM
#3
Junior Member
Join Date: Dec 2008
Location: Fort Lauderdale, Fl
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Pontic Trans Am GTA
Engine: old 350TPI/new LS1
Transmission: old 700R4/new 4L60E
Axle/Gears: 3.27 stock
Re: will a 3rd gen 2.8 v6 iat sensor work on a lt1?
i'm assuming that it should, iat work like a coolant temp sensor...meaning it works off resistance..hopefully the iat for the lt1 and the 2.8 are the same resistance..good luck
Thread
Thread Starter
Forum
Replies
Last Post
efiguy
Engine/Drivetrain/Suspension Parts for Sale
0
09-27-2015 01:30 PM
Dragonsys
Engine/Drivetrain/Suspension Parts for Sale
2
09-25-2015 03:51 PM
