tpi in sacramento pnp
09-10-2013, 05:55 PM
#1
Supreme Member
Thread Starter
iTrader: (2)
Join Date: Sep 2003
Location: Woodland, CA
Posts: 10,494
Likes: 0
Received 3 Likes
on
3 Posts
Car: '02 Z06
Engine: L33 5.7
Transmission: T56
Axle/Gears: Stock IRS
tpi in sacramento pnp
Went to pnp today to gather some factory hardware I misplaced. there was a 91/92 GTA with a full tpi still sitting there. Clean, dent free runners as well. Was thinking about going back tomorrow for it but I am not sure why I need it.
09-10-2013, 06:02 PM
#2
Supreme Member
iTrader: (2)
Join Date: Feb 2006
Location: Sacramento Ca
Posts: 1,262
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 Trans am, 91 Camaro RS
Engine: 355 Sbc, nothin yet
Transmission: 700r4- both
Re: tpi in sacramento pnp
Man, I could use the lower base... may have to take a ride this weekend
09-11-2013, 01:07 AM
#3
Supreme Member
iTrader: (25)
Join Date: Feb 2006
Location: Manteca,California. Nor Cal.
Posts: 7,260
Likes: 0
Received 5 Likes
on
5 Posts
Car: SOLD IT. Mopar guy only now.
Engine: gone
Transmission: gone
Axle/Gears: gone
Re: tpi in sacramento pnp
91/92 is speed density huh, those intakes and computers are worth money are they not? have fun guys!
09-13-2013, 12:38 PM
#4
Moderator
iTrader: (2)
Join Date: May 2001
Location: Sac, CA
Posts: 5,246
Likes: 0
Received 11 Likes
on
8 Posts
Car: '89 GTA
Axle/Gears: 3.27/9-bolt
Re: tpi in sacramento pnp
Thanks for the heads up! It was a '91 GTA/L98.
I dropped by this morning and pulled the taillights, ECM (no prom) and a driver cup holder.
Was trying to get outta there in under an hour, otherwise I woulda grabbed the lower base for you John. The TPI was apart and I didn't really investigate it.
I dropped by this morning and pulled the taillights, ECM (no prom) and a driver cup holder.
Was trying to get outta there in under an hour, otherwise I woulda grabbed the lower base for you John. The TPI was apart and I didn't really investigate it.
09-13-2013, 01:02 PM
#6
Moderator
iTrader: (2)
Join Date: May 2001
Location: Sac, CA
Posts: 5,246
Likes: 0
Received 11 Likes
on
8 Posts
Car: '89 GTA
Axle/Gears: 3.27/9-bolt
Re: tpi in sacramento pnp
Ah, ok. Did you pull the PROM?
I haven't really hit the yards in 10+ years, so it was kinda fun on a day off to hunt for gold.
The tails are starting to delaminate, but were in rad shape otherwise and only $56!
May put them on the GTA, or the old Firebird. Worse case resale is crazy good.
I haven't really hit the yards in 10+ years, so it was kinda fun on a day off to hunt for gold.
The tails are starting to delaminate, but were in rad shape otherwise and only $56!
May put them on the GTA, or the old Firebird. Worse case resale is crazy good.
09-13-2013, 02:08 PM
#7
Supreme Member
Thread Starter
iTrader: (2)
Join Date: Sep 2003
Location: Woodland, CA
Posts: 10,494
Likes: 0
Received 3 Likes
on
3 Posts
Car: '02 Z06
Engine: L33 5.7
Transmission: T56
Axle/Gears: Stock IRS
Re: tpi in sacramento pnp
Nah I didnt think about the ecm/prom until after I had left already. I just started to tear down the TPI (removed the plenum) till I realized, tpi's are a pain in the *** and I didnt need it that bad except for collectors purpose. I dont need more junk!
Trending Topics
09-15-2013, 09:18 AM
#8
Supreme Member
iTrader: (25)
Join Date: Feb 2006
Location: Manteca,California. Nor Cal.
Posts: 7,260
Likes: 0
Received 5 Likes
on
5 Posts
Car: SOLD IT. Mopar guy only now.
Engine: gone
Transmission: gone
Axle/Gears: gone
Re: tpi in sacramento pnp
yeah if someone needs a stock tpi setup go to nearly any swap meet. you'll find them for 100-150 all day.
Thread
Thread Starter
Forum
Replies
Last Post
NBrehm
Engine/Drivetrain/Suspension Parts for Sale
1
08-25-2015 11:49 PM
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
08-12-2015 03:41 PM
