Anyone running 1/2" wheel studs w/ Iroc wheels?
06-07-2007, 09:35 AM
#1
Supreme Member
Thread Starter
iTrader: (7)
Join Date: Oct 2000
Location: Orange County,NY
Posts: 2,112
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1982 Z28
Engine: 355
Transmission: T56
Axle/Gears: 12 Bolt
Anyone running 1/2" wheel studs w/ Iroc wheels?
I need to know what open ended lug nuts you are running if so?
I am using the plain old 13/16" headed ones (open end) you can pick up at Autozone, but the area where the taper meets the flats of the lug nut did into the rim and gouge it out, almost like the taper on them is too wide and/or too short.
What is the factory correct taper for the Iroc wheels anyway? This alone may help me get closer to an answer.
I am using the plain old 13/16" headed ones (open end) you can pick up at Autozone, but the area where the taper meets the flats of the lug nut did into the rim and gouge it out, almost like the taper on them is too wide and/or too short.
What is the factory correct taper for the Iroc wheels anyway? This alone may help me get closer to an answer.
Thread
Thread Starter
Forum
Replies
Last Post
rudolphschenker
Transmissions and Drivetrain
1
09-04-2015 02:41 AM