Set my best 60' time!!
#1
Member
Thread Starter
iTrader: (1)
Join Date: Jul 1999
Location: Tucson, Arizona
Posts: 247
Likes: 0
Received 1 Like
on
1 Post
Car: 1987 IROC Z28
Engine: 6.0L LQ9 crate engine
Transmission: Performa Built 700R4
Axle/Gears: 3.42 10 bolt, Eaton/Moser
Set my best 60' time!!
Took some time, but, finally got into the 1.5s with a 1.59 sec time at SIR in Tucson. I have been at 1.62 secs or so for last two years!!
Couple of notes: My car has a stock '87 T-5 tranny and a stock torque arm. I have been racing that setup since 1999!!! I launch it at about 4k rpm and have a set of Hoosier QTP tires. Car weighes 3,300 lbs. with me and is street legal still in AZ.
Couple of notes: My car has a stock '87 T-5 tranny and a stock torque arm. I have been racing that setup since 1999!!! I launch it at about 4k rpm and have a set of Hoosier QTP tires. Car weighes 3,300 lbs. with me and is street legal still in AZ.
#2
Senior Member
iTrader: (2)
Join Date: Jul 2002
Location: Philly, PA
Posts: 784
Likes: 0
Received 1 Like
on
1 Post
Car: 1986 Camaro SC
Engine: None
Transmission: None
Axle/Gears: Moser 9" W/ spool 3.50 gears
Re: Set my best 60' time!!
Congradualtions. Going into a new 60 foot zone is as good as a new E.T. sometimes. I just finnaly started hitting some 1.5's for great e.t. results
#3
Member
Thread Starter
iTrader: (1)
Join Date: Jul 1999
Location: Tucson, Arizona
Posts: 247
Likes: 0
Received 1 Like
on
1 Post
Car: 1987 IROC Z28
Engine: 6.0L LQ9 crate engine
Transmission: Performa Built 700R4
Axle/Gears: 3.42 10 bolt, Eaton/Moser
Re: Set my best 60' time!!
Thanks FAST 383. I am looking at cams, any suggestions for a NOS roller cam?
Plus, what are your RPM shift points and rev limiter settings?
Plus, what are your RPM shift points and rev limiter settings?
Thread
Thread Starter
Forum
Replies
Last Post