Ohio residents, sell me your boat anchor?
#1
Supreme Member
Thread Starter
Ohio residents, sell me your boat anchor?
Everyone complains that 305's aren't worth much because 350's are cheaper to build for power.
Well I'm looking for a used mill, something that runs, cheap. I need a pre-87 block, complete at least to the heads. I don't necessarily need an intake. Would like the serpentine setup if I could get it, but mostly I need a cheap running mill that I can bolt up my accessories to and slap an intake on to replace my tired 305.
If I could get a 350 cheap I'd go that route, but I only have a few hundred to spend.
It must be pre-87 though, unless you're going to sell me a complete intake as well.
I know that's a tall order, but that's what the internet's for, to look for hard to find things.
I've found rebuilt 305's complete with only 15k on them for $50 on this board, but they were post 87's, and too far for me to drive for.
I'm near Cleveland.
Thanks,
Mathius
Well I'm looking for a used mill, something that runs, cheap. I need a pre-87 block, complete at least to the heads. I don't necessarily need an intake. Would like the serpentine setup if I could get it, but mostly I need a cheap running mill that I can bolt up my accessories to and slap an intake on to replace my tired 305.
If I could get a 350 cheap I'd go that route, but I only have a few hundred to spend.
It must be pre-87 though, unless you're going to sell me a complete intake as well.
I know that's a tall order, but that's what the internet's for, to look for hard to find things.
I've found rebuilt 305's complete with only 15k on them for $50 on this board, but they were post 87's, and too far for me to drive for.
I'm near Cleveland.
Thanks,
Mathius
#2
Junior Member
Join Date: Feb 2006
Location: Montgomery,Il.
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86t/a-ws6
Engine: vortec350tpi
Transmission: s/s-th700r4
Axle/Gears: 3.73posi
305
How far do you want to drive? I'm 45 miles west of Chicago. Got a 305 with 70k on it from my 86t/a tpi ws6. Ran great when pulled.
#3
Supreme Member
Thread Starter
Originally Posted by t/a350vtpi
How far do you want to drive? I'm 45 miles west of Chicago. Got a 305 with 70k on it from my 86t/a tpi ws6. Ran great when pulled.
Mathius
#4
Junior Member
Join Date: Feb 2006
Location: Montgomery,Il.
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86t/a-ws6
Engine: vortec350tpi
Transmission: s/s-th700r4
Axle/Gears: 3.73posi
305
Probably not going to work. I think I'm about 7 hours from you and I want
$300 for it. Will not ship. Good luck .
$300 for it. Will not ship. Good luck .
Thread
Thread Starter
Forum
Replies
Last Post
Stangski09
Engine/Drivetrain/Suspension Parts for Sale
3
11-14-2015 01:27 PM
raymondandretti
Exterior Parts for Sale
0
09-06-2015 12:51 AM