Drivetrain
#1
Supreme Member
Thread Starter
iTrader: (13)
Join Date: Sep 2005
Location: Bellville,Texas
Posts: 1,245
Likes: 0
Received 26 Likes
on
22 Posts
Car: 1985 Iroc-Z
Engine: 440LSX
Transmission: l460e
Axle/Gears: 3.55 Wavetrac
Drivetrain
If all goes well I will be doing my engine/trans swap in about a month. Want to see if I could sell my complete engine and trans with comp.and harness and all emissions and complete exhaust or would it be better to part it out. If someone needs a complete setup here is the description:
5.0 TPI 87,000 miles
700R4 Trans rebuilt at 80,000 miles
Stock driveshaft with new u-joints and balanced
1985 OEM Computor and harness with Hyper-Tech chip
Mass air flow sensor,air filter housing and all related
All emissions,exhaust manifolds,y-pipe,Magaflow cat-back,cat
Engine has new IAC,Summit throttle body,replaced rear main seal and pan gasket,replaced intake manifold gaskets,new cap and rotor,plugs,wires.
New stock radiator,new water pump(Stewart)
All brackets,a/c compressor,new fan belts
In other words ready to install and run.
Let me know and/or give me your opinions.
5.0 TPI 87,000 miles
700R4 Trans rebuilt at 80,000 miles
Stock driveshaft with new u-joints and balanced
1985 OEM Computor and harness with Hyper-Tech chip
Mass air flow sensor,air filter housing and all related
All emissions,exhaust manifolds,y-pipe,Magaflow cat-back,cat
Engine has new IAC,Summit throttle body,replaced rear main seal and pan gasket,replaced intake manifold gaskets,new cap and rotor,plugs,wires.
New stock radiator,new water pump(Stewart)
All brackets,a/c compressor,new fan belts
In other words ready to install and run.
Let me know and/or give me your opinions.
#2
Member
Join Date: Mar 2006
Location: Houston, Texas
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro RS
Engine: 5.0 TBI
Transmission: T5
Axle/Gears: 3.08
Re: Drivetrain
I was wondering if you might still have this setup available. I will be converting my T-5 to a auto pretty soon and will be needing some parts. Also interested in your TPI setup if you have it.
- Rex
- Rex
Thread
Thread Starter
Forum
Replies
Last Post