ZRATED

I had posted a while back about porting 305 heads that I had bought. I did not look at the heads carfully and I just found out they came out of a 350 caprice police car. I was wondering what I have to do to these heads to work well with my 305? I kmow for sure I have to have them shaved down to reduce the 64cc and I will do a mild port job on them too but will these heads work well with my lo3?



------------------
One Tight Teal green 91 RS (my first car
All Rustangs suck!!!!
5.0 TBI with Auto trans
Z-28 wheels
K&n with dual snorkel intake
Tx Smog Pump Delete option
Valve cover breather
Rapid Fire plugs with Accel ignition wires,coil,cap and rotor
Flowtech headers with flowmaster and Half way cutout
B&M shift kit with trans cooler and hurst hotshift fulid
Hypertech thermomaster chip
96 LT1 cam with
New liffters and timing chain
All the free TBI mods

Brian Felts

I can say they will work better than what you got. See if they have 1.94 valves if so you are ok. NO BIGGER! And yes have them milled down. The TBI heads are pitiful in a bad way.


Brian

------------------
1989 Camaro RS

305 .030 over Hydro Pistons
Vortech heads milled to 58cc...Performer RPM intake....LT4 cam..Crane Gold rockers...FastChip custom chip...ALum. Driveshaft...3.73 gears with Posi...underdrive pullys...Rebuilt 700R4 with Vette Servo and B&M shift Kit...MSD ignition...A/C Delete No SMOG junk....1997 SS leather interior...B&M Shifter... Ultimate TBI mods...14X3 K&N open Element Non-Drop...Hooker headers....3" exhaust with Flowmaster Cross flow 16X8 Wheels from 97 RS Spohn LCA's Spohn Panhard Bar..LETS PLAY FORD!!

www.geocities.com/feltsb