How to remove a speedo with a cable
07-18-2003, 12:03 AM
#1
Supreme Member
Thread Starter
Join Date: Aug 2002
Location: Milwaukee, Wisconsin
Posts: 2,076
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1982 Trans Am
Engine: LG4
Transmission: 200C
Axle/Gears: 3:73
How to remove a speedo with a cable
I finally found out a way to do it. I had to take every panel off underneath and cut the zip tie that held the wires to the speedo cable under the dash. I their was finally some slack in the cable. The dash and left speaker had to come out to shine some light to see. I then stuck a screwdriver down the speaker hole to unclip the cable, and the gauges were free.
Now I need some more info on converting to an electric speedo.
Heres one site with some info.
Now I need some more info on converting to an electric speedo.
Heres one site with some info.
07-20-2003, 04:11 PM
#2
Member
Join Date: Oct 2000
Location: Richmond, Yorkshire, U.K
Posts: 307
Likes: 0
Received 0 Likes
on
0 Posts
I undo all the screws that hold the cluster in then undo the speedo cable below the brake servo in the engine bay. Pull the cluster forward and reach behind the cluster and press to release the clip that holds the cable.
Simon
Simon
Needless to say, that's the way I do it too. 
Thread
Thread Starter
Forum
Replies
Last Post
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
1
11-19-2015 07:03 AM
TheTraut88
Engine/Drivetrain/Suspension Parts for Sale
1
09-07-2015 05:22 PM
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
0
09-02-2015 08:43 AM
