A/C conversion question
08-25-2003, 12:53 PM
#1
Member
Thread Starter
Join Date: Jun 2001
Location: Hurlburt Field, Florida
Posts: 296
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Z-28
Engine: 350 SBC
Transmission: Probuilt 700R-4
A/C conversion question
I bought the conversion from autozone but my high pressure fitting is screwed up and leaks out. Now the kit says you don't need it, the fitting is just there to prevent cross contamination. Now how much pressure is an A/C system usually and how much refrigerant do i put in the kit says 85 percent of R-12 but i'm not sure how much R-12 is used in a camaro. Thanks.
08-25-2003, 01:11 PM
#2
Supreme Member
Join Date: Jul 2001
Location: Pueblo Co
Posts: 3,974
Likes: 0
Received 0 Likes
on
0 Posts
Car: No more birdy
To get the correct head pressure you do need the high side fitting but............................................................................................................................................................................................................
Since your not using real guages It doesent really matter. Use 2 1/2 cans of R-134a 1, 8 oz oil charge or 2 cans of 12 oz R-134a and a can 12 oz oil/conditioner and stop leak. That may put you a tad over either way if you get all the oil/freon in but most likely you wont either way its fine.
Since your not using real guages It doesent really matter. Use 2 1/2 cans of R-134a 1, 8 oz oil charge or 2 cans of 12 oz R-134a and a can 12 oz oil/conditioner and stop leak. That may put you a tad over either way if you get all the oil/freon in but most likely you wont either way its fine.
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
10
08-11-2015 10:11 PM
