quick question about holley stealthram
#1
Member
Thread Starter
Join Date: Jun 2005
Location: Maine
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Formula 350
Engine: L98
Transmission: 700-R4
quick question about holley stealthram
I did do a search first and what I found didnt answer my questions. I am really interested in the Holley stealthram set-up and I'm wondering a few things. Do you need to have vortech heads to run this or can I put it on my stock engine with no problems? it says its good for 60 HP and If I can just bolt it on my stock engine I'm probably going to buy it. Thanks alot for the help!
#2
Member
Join Date: Oct 2003
Posts: 126
Likes: 0
Received 0 Likes
on
0 Posts
Car: 67 camaro
Engine: 383 accel dfi
Transmission: t56
you do not need vortec heads, it will bolt onto your stock setup..holley makes one for standard and vortec heads...just make sure you get the one for the standard sbc...also do a search on here for "stealtram fuel lines", you will need a new set of fuel lines..there are several ways to do it..just do a search..good luck
mike
mike
#3
Member
Thread Starter
Join Date: Jun 2005
Location: Maine
Posts: 273
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Formula 350
Engine: L98
Transmission: 700-R4
Since I'm putting this on my stock engine I don't expect 60 HP at all, but will I still see a noticeable difference in power or is it not going to do much? And I was also wondering if I can use my stock throttle body until I can get a 58mm. Thanks
#7
Senior Member
Join Date: May 2002
Location: loxahatchee fla
Posts: 564
Likes: 0
Received 0 Likes
on
0 Posts
Thread
Thread Starter
Forum
Replies
Last Post