Minimum rocker stud length...
10-15-2007, 06:17 PM
#1
Supreme Member
Thread Starter
iTrader: (1)
Join Date: Jun 2001
Location: 600 yds out
Posts: 1,520
Likes: 0
Received 0 Likes
on
0 Posts
Car: Bee-Bowdy
Engine: blowd tree-fity
Transmission: sebin hunnerd
Axle/Gears: fo-tins
Minimum rocker stud length...
I'm using Comp Pro Magnum roller rockers (7/16" stud) and the matching poly locks. What is the minimum amount (length) of rocker stud I need in the poly lock?
I'm concerned that I do not have enough rocker stud thread in the poly lock. The set screw is almost half way down in the nut. I measured and I have .325" rocker stud thread in the poly lock (out of .575" usable).
I had a bad experience once where the top of a rocker stud snapped off. I think this was the problem then.
I'm concerned that I do not have enough rocker stud thread in the poly lock. The set screw is almost half way down in the nut. I measured and I have .325" rocker stud thread in the poly lock (out of .575" usable).
I had a bad experience once where the top of a rocker stud snapped off. I think this was the problem then.
10-16-2007, 03:17 AM
#2
Member
iTrader: (2)
Join Date: Jun 2004
Location: Leadwood, Mo
Posts: 250
Likes: 0
Received 0 Likes
on
0 Posts
Re: Minimum rocker stud length...
This thread may help. https://www.thirdgen.org/forums/tech...ro-magnum.html
Last edited by Kurt04; 10-16-2007 at 03:21 AM.
Thread
Thread Starter
Forum
Replies
Last Post
New2Chevy
Engine/Drivetrain/Suspension Parts for Sale
2
09-28-2015 12:35 AM
355tpipickup
Tech / General Engine
9
09-13-2015 11:35 PM
