dual fan setup ?
01-08-2008, 08:22 PM
#1
Supreme Member
Thread Starter
iTrader: (6)
Join Date: Apr 2005
Location: CT
Posts: 1,459
Likes: 0
Received 1 Like
on
1 Post
Car: 92 trans am clone
Engine: LO3
Transmission: 700r4
dual fan setup ?
i picked up a dual fan setup for my firebird and i have a MAF sensor for my tpi that is on a bracket which is suppossed to fit over it. my bracket doesnt fit over it but hits the pieces holding the right side fan on. so should i cut the plastic to make it lay flat? or will that make it too weak?
01-12-2008, 02:18 PM
#3
Member
Join Date: Oct 2006
Location: Allenhurst, GA
Posts: 320
Likes: 0
Received 0 Likes
on
0 Posts
Car: '81 Z-28
Engine: Soon to be a 383
Transmission: Muncie
Axle/Gears: 3.42
Re: dual fan setup ?
I would try trimming it down some. Just don't cut the whole thing off, it's there for a reason.
01-12-2008, 07:19 PM
#4
Supreme Member
Thread Starter
iTrader: (6)
Join Date: Apr 2005
Location: CT
Posts: 1,459
Likes: 0
Received 1 Like
on
1 Post
Car: 92 trans am clone
Engine: LO3
Transmission: 700r4
Re: dual fan setup ?
thats what i was going to do but im not sure id that alone would weaken it enough but i guess ill give it a go at with the dremel.
01-12-2008, 07:40 PM
#5
Supreme Member
Re: dual fan setup ?
TPI MAF sensors are delicate. They don't like banging against stuff over and over again. Either attach it firmly to something or give enough clearance it hangs out in mid air all by itself, but don't let it rattle against a nearby part.
Thread
Thread Starter
Forum
Replies
Last Post
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
0
09-02-2015 08:43 AM