Compatibility questions using '94 TBI 350 block for L98
11-22-2013, 07:52 AM
#1
Member
Thread Starter
Join Date: Dec 2001
Location: Burnaby, BC, Canada
Posts: 260
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1989 Formula 350
Engine: 5.7L (L98)
Transmission: 700R4
Compatibility questions using '94 TBI 350 block for L98
I'm in the process of swapping all the TPI gear onto a '94 truck block for my '89 Formula 350. Everything has been straight forward so far *crossing fingers*, but I have a question for the last couple of components.
1) The flywheel from the truck motor is much larger than the L98 flywheel. Should I expect any problems, like with balancing?
2) A minor issue, but I'll mention it anyway... The oil pressure sending unit "nut" hits the truck block before it is screwed in very far. I was just going to try grinding it down until it cleared (on the sending unit, not the block).
1) The flywheel from the truck motor is much larger than the L98 flywheel. Should I expect any problems, like with balancing?
2) A minor issue, but I'll mention it anyway... The oil pressure sending unit "nut" hits the truck block before it is screwed in very far. I was just going to try grinding it down until it cleared (on the sending unit, not the block).
Thread
Thread Starter
Forum
Replies
Last Post