Ace

iTrader: (2)

Im just curious cause ive never seen one of these for sale.. but i just finished removing my 92 speed density harness from my car and im thinking of selling it complete with ecm and pretty much every sensor that was on the engine along with the distributor and throttle body..

Anyone have a guess what i should be asking for something like this

i only made the cuts that were required.. power to the sytem and power to the emmissions... everything is labled and in perfect shape

8Mike9

I'd say a 75-100bucks would be fair for the harness alone.

If I had a TPI intake system only and needed ECM and sensors, then I'd pay more.

Best bet would be to clean it all up, lay it out neatly and take a good pic, probably start about 150 for the whole thing and see what happens.

If someone doesn't have it and is looking to convert it's a good deal, since aftermarket harness will runn 200+ in some cases.

Then again, I bought a complete SD TPI setup with harness, ECM, distributor, etc, for 200.00 at a swap meet last summer.

Confuse ya yet?

Ace

iTrader: (2)

you know selling stuff sucks

just the new ignition module cost me 40$ and the oxygen sensor about the same..

any aftermarket harness ive seen is like 500+ and comes with nothing, just the wiring..

this one even has all the emission stuff and can be hooked up with like 12 wires

oh well..

shaggy56

Tell me about it. I have a 2 year 650 holley carb that i couldnt even sell at the swap meet for $75. Damn thing was $250 brand new plus i bought $100 worth of stuff that i threw in with it.