TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

need help bad, out of ideas

Thread Tools
 
Search this Thread
 
Old 12-13-2005, 02:01 PM
  #1  
Supreme Member

Thread Starter
iTrader: (4)
 
87zjeff's Avatar
 
Join Date: Aug 2005
Location: louisville, ky
Posts: 1,366
Likes: 0
Received 0 Likes on 0 Posts
Axle/Gears: '01 3.42 10 bolt
need help bad, out of ideas

yesterday, my car started idleing bad/rough. bad hesitation from idle, erratic/low vacuum reading, loss of power throughout rpm range, shakes real bad. filled up gas tank with 93 octane when the tank was about 1/3 full. symptoms started about 30 miles afer fill-up. does it when hot or cold. vacuum reservoir sucked air in after i pulled a hose off to make sure it was tight. the idle acts like it wants to die/stall. no high idle. checked plugwires/distributor cap/rotor and they all look good. fuel pressure is at 40psi, and timing is good at 6 dgrees btdc.

could this be from bad gas or a fouled plug? ignition control module? ignition coil?

please help.
Old 12-13-2005, 02:27 PM
  #2  
Supreme Member

 
D's89IROCZ's Avatar
 
Join Date: Jan 2003
Location: Ontario, Canada
Posts: 1,931
Likes: 0
Received 1 Like on 1 Post
Car: 1989 IROC-Z
Engine: 5.7L EFI LTR setup
Transmission: T-5 World Class
Sounds like a injector going or is gone . I had the same issues . Check them out .
Old 12-13-2005, 02:28 PM
  #3  
Supreme Member

Thread Starter
iTrader: (4)
 
87zjeff's Avatar
 
Join Date: Aug 2005
Location: louisville, ky
Posts: 1,366
Likes: 0
Received 0 Likes on 0 Posts
Axle/Gears: '01 3.42 10 bolt
i installed them in september. svo injectors. i would hate to think it is them.
Old 12-13-2005, 03:33 PM
  #4  
Supreme Member

 
D's89IROCZ's Avatar
 
Join Date: Jan 2003
Location: Ontario, Canada
Posts: 1,931
Likes: 0
Received 1 Like on 1 Post
Car: 1989 IROC-Z
Engine: 5.7L EFI LTR setup
Transmission: T-5 World Class
Yes that would suck . There is other stuff maybe . When you get it running , is there any black smoke ? This would suggest a spark issue. Any SES codes ? Did you change the constant in the prom to show the injector change ...it would be bad if you didn't .
Old 12-13-2005, 03:36 PM
  #5  
Supreme Member

Thread Starter
iTrader: (4)
 
87zjeff's Avatar
 
Join Date: Aug 2005
Location: louisville, ky
Posts: 1,366
Likes: 0
Received 0 Likes on 0 Posts
Axle/Gears: '01 3.42 10 bolt
it starts fine. the problem occursa after it starts. the injectors were replaced with ones of the same size. there is smoke on start up but it looks more like grey.
Old 12-17-2005, 10:41 PM
  #6  
Member
 
AC398's Avatar
 
Join Date: Nov 2004
Posts: 123
Likes: 0
Received 0 Likes on 0 Posts
Car: Red 89 GTA
Engine: L98
Transmission: 700R4
i had the same kinda thing happen to me last week, put my car on a lift in auto shop installed a wonderbar and when i went to restart my car it wouldnt hold an idle and seemed almost like it was getting enough fuel. when i revved the motor it would rev to like 2500 before it felt like the engine was making any power and was making a backfiring noise out my intake. checked everything and i mean everything with my auto teacher and it wasnt throwing any codes. The idea to disconnect my maf just popped in my brain, did it, and my cars back to idling at 700. Ive had my maf disconnected for a week now and the car runs fine, even ran it at a local track multiple times and was running consistent 14.55-14.7.

oh and the only way i could get my car to hold an idle was with my teacher spraying propane in the brake booster i believe
Old 12-17-2005, 11:00 PM
  #7  
Supreme Member

Thread Starter
iTrader: (4)
 
87zjeff's Avatar
 
Join Date: Aug 2005
Location: louisville, ky
Posts: 1,366
Likes: 0
Received 0 Likes on 0 Posts
Axle/Gears: '01 3.42 10 bolt
i found a broken valve spring. fixed that problem, runs good again.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
redmaroz
Suspension and Chassis
9
04-25-2017 07:14 AM
Wife'sCar
Members Camaros
44
09-30-2015 12:42 PM
19irocz85
Transmissions and Drivetrain
2
08-26-2015 07:54 PM
B_Dubya
Transmissions and Drivetrain
3
08-26-2015 05:09 PM
86IROC112
TPI
12
08-21-2015 07:20 PM



Quick Reply: need help bad, out of ideas



All times are GMT -5. The time now is 01:20 PM.