vaccum lines
#1
Member
Thread Starter
Join Date: Nov 2005
Location: Mlwaukee, WI
Posts: 243
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92 camaro rs
Engine: 305
Transmission: 700r4
vaccum lines
almost done converting my TBI to TPI now i just have to run vaccum lines at work (advance auto parts) we have the hard lines but they are rolled up any ideas on how to get them to lay flat and how to get them to make tighter bends without breaking them
thanks
thanks
#3
Member
Join Date: Jul 2005
Location: Jacksonville, Florida
Posts: 460
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Camaro Z28
Engine: 5.7 LT1
Transmission: 4L60
Axle/Gears: 3.23's
Your using hard lines for vaccum, well on mine all my vaccum lines are soft rubber hosses and one plastic tube that looks like a straw (Im of course referring to my old TPI setup on my LT1 there are some hard vaccum lines).
#4
Senior Member
iTrader: (2)
Join Date: May 2003
Location: Huntsville, AL
Posts: 539
Likes: 0
Received 2 Likes
on
2 Posts
Car: 87 GTA, 88 GTA, 92 TA, 72 RS SS
Engine: 350, 350, 305, 396
Transmission: T56, 700r4, 700r4, T56
Axle/Gears: 3.42, 3.23, 3.23, 3.73
Try using a heat gun to gently heat the line until it is soft and form it to shape you need. Just make sure you don’t collapse them.
Thread
Thread Starter
Forum
Replies
Last Post