really messed up now
#1
Junior Member
Thread Starter
Join Date: Jul 2000
Location: Dubois, PA, USA
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
really messed up now
some of you may remember last week when i posted about starting problems.
https://www.thirdgen.org/messgboard/...ML/001146.html
well i changed the IAC, and control module, turned the key and now its worse. still wont start without the gas depressed but now even with it floored it just puts. sounds really rough. thought maybe snow got inside my cap, so i got a new cap and rotor. still doing the same. when i was looking for the wires to hook back up to the control module, i did see a little connector that wasnt hooked to anything. its coming out of the harness right behind the distributor, it has 2 round prongs. seemed like a pretty short wire but i couldnt see anything (at least looking from the top) that it could have hooked into. think this may be it? got any ideas what it might even be or any other things i might try to change before i blow my money on beer? thanks again
https://www.thirdgen.org/messgboard/...ML/001146.html
well i changed the IAC, and control module, turned the key and now its worse. still wont start without the gas depressed but now even with it floored it just puts. sounds really rough. thought maybe snow got inside my cap, so i got a new cap and rotor. still doing the same. when i was looking for the wires to hook back up to the control module, i did see a little connector that wasnt hooked to anything. its coming out of the harness right behind the distributor, it has 2 round prongs. seemed like a pretty short wire but i couldnt see anything (at least looking from the top) that it could have hooked into. think this may be it? got any ideas what it might even be or any other things i might try to change before i blow my money on beer? thanks again
#2
Member
Join Date: Jul 1999
Location: Norfolk, VA
Posts: 421
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1985 Trans Am
Engine: 305 TPI
Transmission: 700R4
ahhhh... once stupid me reread your post I saw that I was wrong.... anyone else have any ideas??
[This message has been edited by Kevin Irving (edited February 02, 2001).]
[This message has been edited by Kevin Irving (edited February 02, 2001).]
Thread
Thread Starter
Forum
Replies
Last Post