Porting intake 5.7 tpi
#1
Junior Member
Thread Starter
Join Date: Mar 2012
Location: Quad Cities, IA
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Camaro IROC-Z 5.7 TPI
Engine: 350 aka 5.7L Tuned Port Injection
Transmission: 700-R4
Axle/Gears: 3.27 posi
Porting intake 5.7 tpi
I am going to be Porting my intake 5.7 tpi stock. I have searched quite a bit but have not had a direct answer, so here goes.
Which gaskets should I buy? It looks like I need Mr. Gasket 146,for the runners and Plenum. Some have said felpro 1205 for the base but I also heard they do not fit 87 and up cast iron heads. Help pleeeassee. I wanna sherry this done in the next week.
Which gaskets should I buy? It looks like I need Mr. Gasket 146,for the runners and Plenum. Some have said felpro 1205 for the base but I also heard they do not fit 87 and up cast iron heads. Help pleeeassee. I wanna sherry this done in the next week.
#2
Junior Member
Thread Starter
Join Date: Mar 2012
Location: Quad Cities, IA
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Camaro IROC-Z 5.7 TPI
Engine: 350 aka 5.7L Tuned Port Injection
Transmission: 700-R4
Axle/Gears: 3.27 posi
Re: Porting intake 5.7 tpi
BTW I'm planning as much DIY porting as possible on a stock setup
#3
Junior Member
Thread Starter
Join Date: Mar 2012
Location: Quad Cities, IA
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Camaro IROC-Z 5.7 TPI
Engine: 350 aka 5.7L Tuned Port Injection
Transmission: 700-R4
Axle/Gears: 3.27 posi
Re: Porting intake 5.7 tpi
Bump
Thread
Thread Starter
Forum
Replies
Last Post
Fast355
DFI and ECM
14
12-02-2016 06:33 PM
LT1Formula
Engine/Drivetrain/Suspension Parts for Sale
20
11-14-2015 12:02 AM
Sanjay
Engine/Drivetrain/Suspension Parts for Sale
1
08-12-2015 03:41 PM