Finally got rid of my B&M ManualPak!!!
07-08-2002, 09:35 PM
#1
Supreme Member
Thread Starter
Join Date: Nov 1999
Location: Elizabeth, Colorado
Posts: 1,507
Likes: 0
Received 0 Likes
on
0 Posts
Car: '94 Corvette
Engine: LT1
Transmission: 4L60E
Finally got rid of my B&M ManualPak!!!
I slapped on a Trans-Go Full manual shift kit(TH-350-S) over the weekend, and what a charm.
The B&M kit would knock your fillings out. It was way to hard on my transmission, rear end, and u-joints.
I wouldn't take the car over 5000rpm because of fear of blasting my driveshaft off.
The Trans-go is much more mellow. The shifts a positive, and don't transmit shock through out my drive line.
The installation was straight forward, and required me to hook up my vacuum modulator, and didn't require the kick down cable.
That's all...I thought I would share my side by side comparisons.
Ron
The B&M kit would knock your fillings out. It was way to hard on my transmission, rear end, and u-joints.
I wouldn't take the car over 5000rpm because of fear of blasting my driveshaft off.
The Trans-go is much more mellow. The shifts a positive, and don't transmit shock through out my drive line.
The installation was straight forward, and required me to hook up my vacuum modulator, and didn't require the kick down cable.
That's all...I thought I would share my side by side comparisons.
Ron
Last edited by ronterry; 07-09-2002 at 02:33 AM.
Thread
Thread Starter
Forum
Replies
Last Post
