JBert

Gonna be replacing my slave. cyl tomorrow night, and just gathering up some last information.

I found the basic tech article https://www.thirdgen.org/newdesign/t...assembly.shtml


Is there anywhere else or any other site that gives a more detailed description? Just a noob when it comes to stuff like this

Did a search too, didnt help much.

JBert

TTT Anyone?

pasky

Its kinda hard to foul up that job, toughest part (if thats what you wanna call it) is just gonna be bleeding it and putting the fluid in, the slave cylinder unbolts right near the bellhousing, just two nuts, take off the hose from the master cylinder, put new one back in place....done. Be sure not to hit the clutch pedal while your new slave cylinder is not bolted back to the fork, you'll blow it up.