Clutch Replacement Issue
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2006
Location: Ft. Bliss Texas
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Firebird / 1991 Formula
Engine: 350 4BBL / 305 TPI
Transmission: 700 R4 / T 5
Axle/Gears: 9-Bolt Posi / 10 Bolt Posi
Clutch Replacement Issue
So I picked up a Clutch set for my car awhile back, (1991 Firebird Formula, 305 TPI, 5 Speed) and I just got around to doing it today because the throwout bearing on the current clutch came apart. So I get it all disassembled, and as I'm getting ready to put the new clutch in, I notice that the pressure plate for the new clutch is too small. This was a cheap Autozone set up, P/N NU0056. Now, my question here is what the hell is up with that? The clutch disk itself, throwout bearing, and pilot bushing are all the same, the only difference being the pressure plate being to small. With the condition of the car, I dont think it would have an aftermarket flywheel. What part number should be I be looking for for a clutch kit? I'm currently looking at the Zoom clutch kit, P/N MU56-1. Has anyone else had this issue? I was kind of figureing that going to a parts store would provide me with the correct part. Any input would be appreciated. Really p!$$ed about this.
#2
Supreme Member
![](https://www.thirdgen.org/forums/images/ranks/tgo10.gif)
iTrader: (14)
Join Date: Aug 2006
Location: Central NJ
Posts: 12,654
Likes: 0
Received 47 Likes
on
45 Posts
Car: 86 Trans Am, 92 Firebird
Engine: 408 sbc, 3.1L of raw power
Transmission: TKO600, T5
Axle/Gears: Moser 9", 3:70 trutac, 3:23 torsion
Re: Clutch Replacement Issue
well, autozone is not the best parts store in the world, most of their stuff is average/below average quality. they are like the Homedepot of auto stores.
its possible the clutch kit you received just has the wrong pressure plate in the box.
I have a zoom clutch, but its the kevlar race setup, not the organic one. I have had no problems, its been a really great clutch
its possible the clutch kit you received just has the wrong pressure plate in the box.
I have a zoom clutch, but its the kevlar race setup, not the organic one. I have had no problems, its been a really great clutch
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Tech / General Engine
4
09-17-2020 08:26 AM