mini ram gang
Thread Starter
Joined: Nov 2000
Posts: 1,420
Likes: 5
From: Byhalia MS, just south of memphis
Car: 89 Firebird
Engine: 6.0 LS
Transmission: T-56
Axle/Gears: 3.70
mini ram gang
on the TPIS site they have the fuel lines that fit direct to the stock GM setup. from what I have seen all of the MR's have the lines coming out of the back, do they go all the way up to the stock pos or is everyone doing something different?
Joined: Jun 2000
Posts: 5,364
Likes: 51
From: Enschede, Netherlands
Car: 82 TA 87 IZ L98 88 IZ LB9 88 IZ L98
Engine: 5.7TBI 5,7TPI 5.0TPI, 5,7TPI
Transmission: T5, 700R4, T5, 700R4
Axle/Gears: 3.08, 3.27, 3.45, 3.27
Re: mini ram gang
The hard lines that are optional run from the back under the miniram to the front. I have some but didn't use them. Too cumbersome. Easier to just plumb to the rear
Thread Starter
Joined: Nov 2000
Posts: 1,420
Likes: 5
From: Byhalia MS, just south of memphis
Car: 89 Firebird
Engine: 6.0 LS
Transmission: T-56
Axle/Gears: 3.70
Re: mini ram gang
in what way are they cumbersome? I may headache that vs running them from the frame rails then back.
Joined: Oct 2001
Posts: 12,228
Likes: 1,156
From: Il
Car: 1989-92 FORMULA350 305 92 Hawkclone
Engine: 4++,350 & 305 CIs
Transmission: 700R4 4800 vig 18th700R4 t56 ZF6 T5
Axle/Gears: 3.70 9"ford alum chunk,dana44,9bolt
Re: mini ram gang
I have mine run to the front.
Senior Member
Joined: Aug 2004
Posts: 991
Likes: 24
From: Peoria, AZ
Re: mini ram gang
Just plumbed ours using braided steel line to the back on the intake fuel rails. I'm not a big fan of putting the fuel lines next to the alternator the way GM did on the TPI units.
Thread
Thread Starter
Forum
Replies
Last Post