parts for sale
parts for sale
all parts have 5000 miles on them and fit a small
block chevy
msd blaster coil
msd 6al
msd btm
msd pro billet dist w/ new rotor and new ford cap
adapt
accel 8.8 wires
at1 d1 supercharger for sbc 15 psi pulley
griffen alumnium radiator
set of lt1 electric fans(bolt in mod on a thrid gen)
dart 215 ironeagle heads
arp head bolt set
7.5 inch rearend with 3:08 gears lsd and disks
7.5 inch rear with 4:10s auburn posi and disks
b&m pro ratchet shifter for a 3 speed (can buy adapter
for a 4 speed)
msd knock sensor with gauge (for detonation)
o2 sensor with dynotune digital a/f gauge
auto meter gauages oil water boost monster tach
16x8 trans am gta wheels
headers with h pipe and true duals for a 3rd gen f
body
roll bar for a 3rd gen f body 4 point
leather seats from a 95 z28
t 350 manual valve body and 3500 stall
t-tops for 3rd generation f bodys 3 sets
hatch for a third gen has a firebird acid etched in
carpet and interior panels for 3rd gen ta
dash pad for 3rd gen ta
dash board with 145mph speedo 3rdgen
t350 changeover kit for 3rd gen
2 gas tanks for third gen one f/i one for carb
msd ign module for hei dist
set of 3rd gen front and rear rotors less then 5k on them
murrays lifetime warrenty (127$$) alternator
sbc oil pan with trap door and baffles
spindles and control arms for 3gen
3rd gen ta hood with all vents
side fendor vents
sterring coloum for 3rd gen ta
center console for 3rd gen ta
delco radio
power hatch pull down
sidewindow glass
crager pro stars 15x4 and 15x10 5 on 4.75 bolt pattern
paxton electric fuel pump (its the aeromotive pump but
in blue)
boost sensitive fuel press reg
holley 750 modified for boost
wieand stealth intake for sbc
alunium full roller rockers 1.5/1.6
im parting out a 86 ta if u need anything i havent listed ask i may have it
any questions send me an email
ta12sec@yahoo.com
make an offer on anything if its reason able it wont
be refused everything has to go i have to clean out the garage in order to
store the hawk this winter
brad
1999 firehawk 484
block chevy
msd blaster coil
msd 6al
msd btm
msd pro billet dist w/ new rotor and new ford cap
adapt
accel 8.8 wires
at1 d1 supercharger for sbc 15 psi pulley
griffen alumnium radiator
set of lt1 electric fans(bolt in mod on a thrid gen)
dart 215 ironeagle heads
arp head bolt set
7.5 inch rearend with 3:08 gears lsd and disks
7.5 inch rear with 4:10s auburn posi and disks
b&m pro ratchet shifter for a 3 speed (can buy adapter
for a 4 speed)
msd knock sensor with gauge (for detonation)
o2 sensor with dynotune digital a/f gauge
auto meter gauages oil water boost monster tach
16x8 trans am gta wheels
headers with h pipe and true duals for a 3rd gen f
body
roll bar for a 3rd gen f body 4 point
leather seats from a 95 z28
t 350 manual valve body and 3500 stall
t-tops for 3rd generation f bodys 3 sets
hatch for a third gen has a firebird acid etched in
carpet and interior panels for 3rd gen ta
dash pad for 3rd gen ta
dash board with 145mph speedo 3rdgen
t350 changeover kit for 3rd gen
2 gas tanks for third gen one f/i one for carb
msd ign module for hei dist
set of 3rd gen front and rear rotors less then 5k on them
murrays lifetime warrenty (127$$) alternator
sbc oil pan with trap door and baffles
spindles and control arms for 3gen
3rd gen ta hood with all vents
side fendor vents
sterring coloum for 3rd gen ta
center console for 3rd gen ta
delco radio
power hatch pull down
sidewindow glass
crager pro stars 15x4 and 15x10 5 on 4.75 bolt pattern
paxton electric fuel pump (its the aeromotive pump but
in blue)
boost sensitive fuel press reg
holley 750 modified for boost
wieand stealth intake for sbc
alunium full roller rockers 1.5/1.6
im parting out a 86 ta if u need anything i havent listed ask i may have it
any questions send me an email
ta12sec@yahoo.com
make an offer on anything if its reason able it wont
be refused everything has to go i have to clean out the garage in order to
store the hawk this winter
brad
1999 firehawk 484
Thread
Thread Starter
Forum
Replies
Last Post







