Removing rust from part on trunk
Thread Starter
Supreme Member
Joined: Aug 2002
Posts: 2,076
Likes: 0
From: Milwaukee, Wisconsin
Car: 1982 Trans Am
Engine: LG4
Transmission: 200C
Axle/Gears: 3:73
Removing rust from part on trunk
Hey I would like some input to get rid of the rust around the area in the pic. My thoughts are to raise the trunk, and tape around everything that could possible be covered in paint. Then use a dremel to remove the rust, and some acid if necessary.
Once all the rust is removed I plan to use primer in a spray can.
After the primer is dry, is it ok to spray the entire thing? Do I need to remove all of the paint?
Once all the rust is removed I plan to use primer in a spray can.
After the primer is dry, is it ok to spray the entire thing? Do I need to remove all of the paint?
Senior Member
Joined: Jul 2001
Posts: 839
Likes: 0
From: Valley Head, AL
Car: 1983 Camaro "SC-350"
Engine: Mild 350 4-bolt
Transmission: 700R4 w/ TCI Stall
Why not just use sandpaper to remove the rust?
I don't quite understand what you're asking in the last question either?
I don't quite understand what you're asking in the last question either?
Thread
Thread Starter
Forum
Replies
Last Post