how should i go about gettin the rubberized coating out of my rear wheel wells. i have a lot of rust forming behind some of the rubbercoating so i need to get it all out and sand blast the entire well then use some type of bed liner in there.

 

I had to fix some spots of rust there too. I used a paint scraper to get the big chunks off, wire brush (cup type) on a drill to get more off and then scubbed it with a rag soaked in mineral spirits. I then pop-rivited a patch in and sealed it withe POR15 patch. I want to do the rest of the inner fenders but will probably wait til winter.
I had a fuel line let go near the tank and the gas did a great job removing the undrcoating too-

 

ill give that a shot. i thought of sand blasting it off? i have a sand blaster if that will work i might as well try it i guess. anyone know?

 

You sure it's not melted tire

 

Heat it with a propane bottle and do a bit of scraping.

JamesC

 

theres quite a bit of that in there to, crack sealer burnouts make a big mess.