Auto Detailing and Appearance Share tips and tricks on how to make your Third Gen shine! Get opinions on products or how something tasteful looks on your Chevrolet Camaro or Pontiac Firebird.

Where to put this emblem

Thread Tools
 
Search this Thread
 
Old Jan 28, 2006 | 08:27 AM
  #1  
rjpbboi's Avatar
Thread Starter
Member
 
Joined: Nov 2005
Posts: 233
Likes: 0
From: Massachusetts
Car: 87 Trans Am, 89 RX7
Engine: 350tpi,350carb
Transmission: T-5,t56
Axle/Gears: 3.42 Posi,4.11 posi
Where to put this emblem

I have purchased this emblem off TPIparts http://tpiparts.net/inc/sdetail/1331 and I was wondering if you guys knew of a good place on the bumper to put it. Pics would be greatly appreciated. Thanks.
Reply
Old Jan 28, 2006 | 10:04 AM
  #2  
gilley's86's Avatar
Member
 
Joined: Jun 2003
Posts: 204
Likes: 0
From: Nebraska
Car: 1986 Camaro SC
Engine: 305, AKA 30WHY
Transmission: 700R4
If I remember correctly, it goes on the driver's side of the rear bumber. There should be an indentation in the bumber where it should fit into.

Gilley's86
Reply
Old Jan 28, 2006 | 10:04 AM
  #3  
Lunatic0987's Avatar
Junior Member
iTrader: (2)
 
Joined: May 2003
Posts: 40
Likes: 0
From: DE
Car: 89 Formula 350
Engine: 355
Transmission: 700R4
Put it in the stock location for those emblems. Sorry I couldent get a better pic, but here ya go..
Attached Thumbnails Where to put this emblem-792285_5_full.jpg  
Reply
Old Jan 28, 2006 | 11:24 AM
  #4  
a mack6's Avatar
Supreme Member
iTrader: (1)
 
Joined: Mar 2004
Posts: 1,319
Likes: 1
From: Pittsburgh & Allentown PA
Car: 1992 Z28 (Heritage Edition)
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: 2.73 Posi
Re: Where to put this emblem

Originally posted by rjpbboi
I have purchased this emblem off TPIparts http://tpiparts.net/inc/sdetail/1331 and I was wondering if you guys knew of a good place on the bumper to put it. Pics would be greatly appreciated. Thanks.
IIRC those emblems were only on camaros, so therefore there is no groove in the TA bumper to put it. you could put it somewhere on the bumper but its up to you as to where. I think that you should offset it like the ones are on the camaro...to the right.
Reply
Old Jan 28, 2006 | 11:40 AM
  #5  
shr00m's Avatar
Senior Member
iTrader: (2)
 
Joined: Oct 1999
Posts: 893
Likes: 0
From: Hattiesburg, MS, USA
Car: 1992 Jade Green---Trans Am Converti
Engine: LS1
Transmission: T56
There should be a small flat section under the taillights, before it juts out for the bumper. I've seen them there and they look pretty good.

Kevin D.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Jake_92RS
Tech / General Engine
8
Jan 28, 2020 10:37 PM
69 Six Pack
Camaros for Sale
13
Oct 5, 2015 07:51 PM
dyeager535
DIY PROM
7
Aug 28, 2015 08:10 AM
michealleger
Engine Swap
5
Aug 26, 2015 03:29 PM
Fronzizzle
Electronics
2
Aug 9, 2015 01:15 PM




All times are GMT -5. The time now is 03:12 AM.