Workmans fender covers?
Thread Starter
Supreme Member
Joined: Sep 2002
Posts: 1,500
Likes: 0
From: Dallas/Fort-Worth
Car: 1988 Camaro IROC-Z
Engine: 350 TPI (L98)
Transmission: T56
Axle/Gears: 9-bolt 3.45
Workmans fender covers?
Are there any fender covers for the third gens? The ones that I have found appear to be shaped for trucks or something. Plus I want one that says chevrolet or camaro or something.
For all of you that don't know what a fender cover is:
For all of you that don't know what a fender cover is:
TGO Supporter
iTrader: (2)
Joined: Jul 1999
Posts: 13,579
Likes: 9
From: Readsboro, VT
Car: 85 IROC-Z / 88 GTA
Engine: 403 LSx (Pending) / 355 Tuned Port
Transmission: T56 Magnum (Pending) / T5
Axle/Gears: 3.42 / ?
I'm not aware of any application specific models, but the generic ones work just fine on thirdgens. I've got one that I bought at a swap meet a few years ago with "CAMARO" written on it.
Ironically enough, they had "CORVETTE" ones with the C4 logo on them too.
Ironically enough, they had "CORVETTE" ones with the C4 logo on them too.
Thread Starter
Supreme Member
Joined: Sep 2002
Posts: 1,500
Likes: 0
From: Dallas/Fort-Worth
Car: 1988 Camaro IROC-Z
Engine: 350 TPI (L98)
Transmission: T56
Axle/Gears: 9-bolt 3.45
Dang. I was trying to find one that was application specific so it would be easier to work with. Most of the time the covers buldge up or slide off.
Thread
Thread Starter
Forum
Replies
Last Post
morrow
Suspension and Chassis
78
Jan 13, 2024 12:29 PM
355tpipickup
Tech / General Engine
9
Sep 13, 2015 11:35 PM
