I have a 91 firebird with no ground fx. Is it possible to get the sides and rear ground fx off an older bird like an 89 or so? Will it fit? I want to try this out. I'd have those on there then I'd take the fx off of a 91 - 92 bird (Just the nose part) and put those under my nose of the bumper. Has anyone tried this before and would it look good?

 

The rear bumper part of the stock gfx is molded in (not seperate piece)

You'd need a rear cover the 2 sides and the small pieces in the back. I'm looking for the same deal, but am holding out for the 91, 92 bumpers.

I know the camaros had the front bumper that was made specifically for gfx, but am not sure about the birds, so i could use some help also.



[This message has been edited by JoelOl75 (edited March 29, 2001).]

 

These pics may be big. Here's a formula W/O the pieces for the GFX on it. My car, has the GFX pieces on the front bumper.







[This message has been edited by Ovrclck350 (edited March 29, 2001).]

 

yea that's what i want on the front nose part of the gfx..but on the sides from a older model firdbird where the gfx look kinda square or flush...and the rear bumber i guess i could just get the whole bumper replaced with the older bumper too.

 

haha woa one heck of a typo....**FIREBIRD**