How wide should I make my stripes?
Thread Starter
Member
Joined: Jun 2001
Posts: 256
Likes: 0
From: Delano, Minnesota
Car: 1986 Camaro
Engine: 383 Stroker
How wide should I make my stripes?
I am thinking about painting stripes on my car and I was wondering how wide I should make each stripe and how big of gap inbetween?
------------------
91 Camaro RS
Red V8 coupe,
Ground effects,
Stingray "intake" on Hood,
Alum. Rims,
Sony Deck,
Rockford Fosgate punch 400 amp,
Two Rockford Fosgate 12 inch subs,
Tinted windows,
White face gauges,
GTR Carbon Fiber Rear Wing
Working on more mods for speed.
"Speed kills, wanna live forever? Drive a Ford"
------------------
91 Camaro RS
Red V8 coupe,
Ground effects,
Stingray "intake" on Hood,
Alum. Rims,
Sony Deck,
Rockford Fosgate punch 400 amp,
Two Rockford Fosgate 12 inch subs,
Tinted windows,
White face gauges,
GTR Carbon Fiber Rear Wing
Working on more mods for speed.
"Speed kills, wanna live forever? Drive a Ford"
Supreme Member
iTrader: (2)
Joined: Nov 2000
Posts: 1,188
Likes: 2
From: Ft Worth, TX USA
Car: 2016 Ram 1500
Engine: 3.0L Diesel
Transmission: 8sp
man this is the last time I post pics off photopoint ( that sh*t is a pain in my A**)
I like my width (18" each side)
I wouldent mind thinner ones but you have to promise to be creative and not just do full length viper stripes. although it looks good it is really over done.
------------------
88 WS6 T/A 305 TPI--
K&N,Air foil,hypertech chip, thermostat+fanswitch
free mods, dynomax catback, urethane motor+trans mounts,
SSM SFCs, Bilsteins
very trick homemade ramair, Accel 300+ ignition system.
Planning: hedman 1-5/8 longtubes, NOS 150 plate, world 305 heads, replace the "peanut"! and other susp. mods.
check it out at:
http://www.geocities.com/transam617
I like my width (18" each side)
I wouldent mind thinner ones but you have to promise to be creative and not just do full length viper stripes. although it looks good it is really over done.
------------------
88 WS6 T/A 305 TPI--
K&N,Air foil,hypertech chip, thermostat+fanswitch
free mods, dynomax catback, urethane motor+trans mounts,
SSM SFCs, Bilsteins
very trick homemade ramair, Accel 300+ ignition system.
Planning: hedman 1-5/8 longtubes, NOS 150 plate, world 305 heads, replace the "peanut"! and other susp. mods.
check it out at:
http://www.geocities.com/transam617
Thread
Thread Starter
Forum
Replies
Last Post
9192camaro
Engine/Drivetrain/Suspension Parts for Sale
16
Feb 3, 2019 12:21 AM
Glowsock
Tech / General Engine
3
Jan 9, 2017 04:06 PM
diana227vegas
Camaros for Sale
10
Jul 8, 2016 12:27 AM





