re-polishing intake
Thread Starter
Member
iTrader: (2)
Joined: Apr 2006
Posts: 408
Likes: 0
From: newark, De
Car: 85 trans am
Engine: 383 stroker
Transmission: 5 speed
Axle/Gears: 9 bolt rear 3:70
re-polishing intake
i have a vic jr intake that i want have repolished. it has wore off in a couple of spots. does anyone do this or can reccomend someone that would or know how much it may cost?
Thread Starter
Member
iTrader: (2)
Joined: Apr 2006
Posts: 408
Likes: 0
From: newark, De
Car: 85 trans am
Engine: 383 stroker
Transmission: 5 speed
Axle/Gears: 9 bolt rear 3:70
Joined: Dec 2008
Posts: 2,540
Likes: 0
From: Norwalk, CA
Car: 91Z28
Engine: 5.7 ls1
Transmission: 4l60e
Axle/Gears: 3.42
Re: re-polishing intake
it depends is it powder coated or just polished i re polish mine just with some very fine steel wool (0000) and it looks good again
Thread Starter
Member
iTrader: (2)
Joined: Apr 2006
Posts: 408
Likes: 0
From: newark, De
Car: 85 trans am
Engine: 383 stroker
Transmission: 5 speed
Axle/Gears: 9 bolt rear 3:70
Re: re-polishing intake
i dont think that will work it looks like there are a couple of spots where it has worn off completely
Joined: Dec 2008
Posts: 2,540
Likes: 0
From: Norwalk, CA
Car: 91Z28
Engine: 5.7 ls1
Transmission: 4l60e
Axle/Gears: 3.42
Re: re-polishing intake
Or you could just type in plenum polish in the search and it will tell how to do it and it will look just like a professional job
this is how mine finished off
It just makes the engine look so much better
this is how mine finished off
It just makes the engine look so much better
Last edited by SiCkRs; Apr 5, 2009 at 12:37 PM.
Thread
Thread Starter
Forum
Replies
Last Post
jerflash
Engine/Drivetrain/Suspension Parts for Sale
5
Sep 24, 2015 03:11 PM
toronto formula
Engine/Drivetrain/Suspension Parts for Sale
3
Sep 10, 2015 07:31 AM
e3pres
Engine/Drivetrain/Suspension Parts for Sale
1
Sep 9, 2015 01:51 PM