And I come across these. The yard I was at had about 8 4th gen and about 7 third gen f-bodys in it. There was three sets but these were the best looking. I only wanted the front two so the guy gave me a good deal on them. After a lot of cleaning they're turning out pretty good. He also had a set of red and black ones but wouldnt sell them because they were so rare and he wanted to hang on to them. The drivers side is also power by the way

 

I was also surpised how light they are compared to my old ones. Even the power one is lighter than my old factory ones

 

What's that picture in the second post of? Am I the only one seeing nothing but a blank picture?

 

They must be REALLY REALLY REALLY light!

 

actually the second pic was supposed to be a close up of the 30th anniversary logo on the back but the pic was to big to post so i downsized it to fit in the post but then it just turned out white. I have no idea why. Also for those ppl who have put these in their car how do you get the seatbelt to go through theguide on the side of the seat. At the yard i had to take the seatbelt off of the car and work it throught the guide to get it out. On my seatbelts in the car now its impossible because there is no way for the whole assembly at either end to fit through that little seat bely guide hole. Jus curious and I hope someone can shed a little light on this subject

 

What I did was cut the seatbelt holder between the 2 screw holes. Then when you screw it back on it stays together.

 

now the pic should work