I pick up a set of 4th gen seats that I want to install in a 3th gen firebird. The seats are leather with lumbar pads installed. The connectors under each seat has 6 wires with 2 hoses going to each seat's bladder. I have told that the bladers are connected to the vaccum from the engine.(I don't think this is right ) Under the right seat there is what I think is a compressor for the bladers. Dose anyone know anything about these seat? How to wire into into fuse pannal? I have not been able to fine anything on these seats

Thanks for any help:lala:

 

Hello Bill89,

Try the link below, it might help you some.

https://www.thirdgen.org/schematics/1988/GTA/

 

Did it help ?

 

Bo it didn't but thanks for your help.