help removing rears seats
Supreme Member
iTrader: (17)
Joined: Feb 2003
Posts: 2,182
Likes: 1
From: Buckley AFB, CO / Crestview, FL
Car: 83 Z-28
Engine: LG4
Transmission: 700R4
Axle/Gears: 02 WS6 Rear w/3:42
Its simple bro. 2 nuts hold the back pieces on and 1 bolt holds the bottom piece on. I think they are 10mm.
Mike
Mike
Last edited by Zrated83; Mar 29, 2004 at 10:19 PM.
Senior Member
Joined: Oct 2003
Posts: 942
Likes: 0
From: LaGrange (10min from Poughkeepsie), NY
Car: 1992 Camaro RS - not real slow anymore...
Engine: SPDC 360 MAF EFI /w a Holley Stealth Ram
Transmission: T5 untill it blows up from to much torque
Axle/Gears: Ford 9" /w auburn pro & 3.89's
Are you asking how to take the seats out? As in... you don't know where the bolts are? I pretty sure the bolts for the bottom parts are directly under them and the tops have a bolt on the side(closest to outside of car). Just look, you'll see it.
Senior Member
Joined: Dec 2002
Posts: 725
Likes: 1
From: Vancouver, B.C.
Car: 87 GTA 120,000k, 90 CRX Si
Engine: 5.7 TPI, 1.6L 16 valve SOHC
Transmission: 700r4, 5spd std
Axle/Gears: 3.73
yes its very easy..the 2 holding the bottom part of the seat down and then u should be able to see exactly what bolts to take the top part off
Member
Joined: Mar 2003
Posts: 479
Likes: 0
From: delaware
Car: 1990 Formula
Engine: 305 TBI (LO3)
Transmission: 5 speed manual
On the bottom part in the front dead center under the bucket there is one 13mm bolt for each, take that off and on the sides you will see 2 more facing downward also 13mm. The seat belt guides are the hard part they have torx bolts with loc-tite on them so make sure you have a torx set for your ratchet.
Thread
Thread Starter
Forum
Replies
Last Post