Still cant get side skirts off!?
Thread Starter
Member
Joined: Dec 2003
Posts: 441
Likes: 1
From: Suffield, CT
Car: Looking
Still cant get side skirts off!?
Its now 10:05, and Im still at work tryin to get some much needed work done to the Camaro. I have every possible nut taken off on the side skirts, but I cant find the final nut/bolt holding the skirts on up front. Its somewhere around where the RS badging is.
Help!
Help!
Supreme Member
iTrader: (17)
Joined: Feb 2003
Posts: 2,182
Likes: 1
From: Buckley AFB, CO / Crestview, FL
Car: 83 Z-28
Engine: LG4
Transmission: 700R4
Axle/Gears: 02 WS6 Rear w/3:42
I just did this so I know where they are all at 
There are two nuts holding the ground effect on near the emblem. You have to loosen up the wheel well cover to get access to them. There is also one nut holding it on at the other side. You have to take an interior panel off to reach that. Then you just have your screws on top and along the bottom.
There are two nuts holding the ground effect on near the emblem. You have to loosen up the wheel well cover to get access to them. There is also one nut holding it on at the other side. You have to take an interior panel off to reach that. Then you just have your screws on top and along the bottom. 
I thought they'd be in there hehe. 
Member
Joined: May 2000
Posts: 415
Likes: 0
From: Chilliwack, BC
Car: 1992 Camaro RS
Engine: 5.7 V8 TPI
Transmission: T-5 5-Speed Manual
Did you take out the 2 phillips head screws that are located behind the RS badge on the rocker panel? Most people forget them because they are concealed, you must remove the badge to get to 'em.
Originally posted by CanadianCamaro
Did you take out the 2 phillips head screws that are located behind the RS badge on the rocker panel? Most people forget them because they are concealed, you must remove the badge to get to 'em.
Did you take out the 2 phillips head screws that are located behind the RS badge on the rocker panel? Most people forget them because they are concealed, you must remove the badge to get to 'em.
Trending Topics
Supreme Member
iTrader: (5)
Joined: Dec 2001
Posts: 2,873
Likes: 5
From: East Tennessee
Car: 1992 Z28 Heritage Edition
Engine: L98
Transmission: T56
Axle/Gears: 3.23:1
The 85-90 gfx have the 2 screws behind the bading. There are too bolts on either side of the Badge that hold the 91-92 GFX on up front.
Thread
Thread Starter
Forum
Replies
Last Post
Hotrodboba400
Firebirds for Sale
3
Dec 10, 2019 07:07 PM
Hotrodboba400
Firebirds for Sale
0
Sep 2, 2015 07:28 PM
