Fastening Headliner
Supreme Member
iTrader: (1)
Joined: Oct 2004
Posts: 3,361
Likes: 1
From: Worcester, MA
Car: 86 T/A
Engine: HSR 355
Transmission: 700R4
Axle/Gears: 2.77 posi
By the other parts around it. Sun visors, pillars, plastic where the sail panels are, etc. No actual fasteners.
Member
Joined: Nov 2004
Posts: 205
Likes: 0
From: Virginia Beach, Virginia
Car: Firebird
Engine: 2.8
Transmission: 5spd
well..actually if you have t tops..theres two clips in the front...what i did, cause when i took it out..they broke..i bought 2 interior clips...cut the heads so tehy fit in the existing hole on the board...and fiberglassed it in place..the clips held strong as hell...and now its fastend tight to the roof..but im not sure about reg. roofs
Member
Joined: Aug 2001
Posts: 126
Likes: 0
From: Concord, CA
Car: 91 Z28
Engine: 5.7 TPI
Transmission: ProBuilt 700-R4 & Vigilante Torque Converter
I have a hardtop and there were three plastic clips towards the front of the headliner (near the windshield). Unfortunately I ripped the metal staple out of my headliner which holds the plastic clips..... Now I'm playing with all sorts of fiberglass resins and what not to reattach the darn thing.
Member
iTrader: (2)
Joined: Feb 2004
Posts: 395
Likes: 0
From: Key West, FL
Car: 1991 Pontiac Firebird
Engine: TBI 5.7L v8
Transmission: Modified T-5
Well I'm glad i read this thread... I'm planning on taking my headliner down today. Any suggestions on how to remove it w/o braking the clips??
Joined: Jun 2003
Posts: 5,028
Likes: 78
From: Desert
Car: 1991 Z28 Vert
Engine: 383 single plane efi
Transmission: T-56
Axle/Gears: 8.8 with 3.73s
Originally posted by 89firebirdguy05
well..actually if you have t tops..theres two clips in the front...what i did, cause when i took it out..they broke..i bought 2 interior clips...cut the heads so tehy fit in the existing hole on the board...and fiberglassed it in place..the clips held strong as hell...and now its fastend tight to the roof..but im not sure about reg. roofs
well..actually if you have t tops..theres two clips in the front...what i did, cause when i took it out..they broke..i bought 2 interior clips...cut the heads so tehy fit in the existing hole on the board...and fiberglassed it in place..the clips held strong as hell...and now its fastend tight to the roof..but im not sure about reg. roofs
Mine is the t-top and the front is where it's hanging down a little. The guy didn't put the visors back in either. So there should be some clips at the windshield? Autozone carries them? Thanks fellas! I will check into it tomorrow.
Thread
Thread Starter
Forum
Replies
Last Post
Bohemian
History / Originality
24
Aug 15, 2017 05:11 PM
formula00ra
Interior Parts Wanted
1
Sep 28, 2015 11:50 AM





