SES Bulb
Thread Starter
Member
Joined: Jul 2003
Posts: 361
Likes: 0
From: Huntington, West Virginia
Car: 1985 Camaro Z/28
Engine: L69
Transmission: 700r4
Axle/Gears: One-Wheel-WOnder 3.08
SES Bulb
Ok guys I feel pretty stupid asking this question but...
How do you take the SES buld out of the guage panel? The little hole is too small for me to fit 2 fingers in to pull it out. I'm sure it's a very obvious answer but I'm at my wit's end. Thanks
How do you take the SES buld out of the guage panel? The little hole is too small for me to fit 2 fingers in to pull it out. I'm sure it's a very obvious answer but I'm at my wit's end. Thanks
Member
Joined: Dec 2005
Posts: 127
Likes: 0
From: Terre Haute, Indiana
Car: 1985 Camaro
Engine: 350 .030 over (355)
Transmission: 700-R4
You have to take the panel out and then you can pull it out from the back. There should be some screws that are 1/4" if I'm thinking right around the guages, take those out, undo the speedo cable, and then it should pull right out. My speedometer was broken whan I got my car and I hated trying to get the speedo cable unplugged and plugged back in, I had to do it blind and could barely fit my hand back there.
Joined: Aug 1999
Posts: 19,282
Likes: 103
From: Lawrence, KS
Car: Met. Silver 85 IROC/Sold
Engine: 350 HO Deluxe (350ci/330hp)
Transmission: T-5 (Non-WC)
Axle/Gears: Limited Slip 3.23's
Thread
Thread Starter
Forum
Replies
Last Post