Front Bumper Alignment
Thread Starter
Senior Member
iTrader: (1)
Joined: Jun 2006
Posts: 692
Likes: 1
From: Oviedo,Florida
Car: 86' Trans am
Engine: 85 LG4-non cc carb(building a 350)
Transmission: Rebuilt 700R4,vette servo,2200stall
Axle/Gears: 2.73 Posi
Front Bumper Alignment
is there any way that i can get my bumper 2 it flush again against my hood or do i have 2 buy a new support bar heres a pic
Junior Member
Joined: Apr 2006
Posts: 53
Likes: 0
From: Victoria, B.C.
Car: 1986 Iroc-Z
Engine: 350cid crate
Transmission: t5- 5speed
Axle/Gears: stock
i got in a bit of a fender bender a while ago in my 86 iroc. no damage other than the gap between the hood and nose widened. simply loosen as many of the bolts holding it on as u can and get a friend to lift the front as u re-tighten them. This fixed my problem. almost everything is ajustable on the f-bodies. u just gotta play with it a bit to get it to line up right.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
