89 trans am Front bumper
Thread Starter
Member
iTrader: (4)
Joined: Oct 2006
Posts: 304
Likes: 0
Car: 1989 Trans Am
Engine: 5.0 TPI
Transmission: 5 Speed Manual
Axle/Gears: Stock Rear End
89 trans am Front bumper
well the front bumper on my trans am is cracked, bent and squared off where the front lisence plate goes. I am going to replace it soon and was wondering if there are any tips on removing it, thanks
Banned
Joined: Sep 2005
Posts: 99
Likes: 0
From: York
Car: 84' z28
Engine: Built 350 SB 4 Bolt, Bored .30 Over
Transmission: 700r4
Axle/Gears: 3.42
pretty sure its just held on by rivet type things, your going to have to replace them when you take them off anyway so i dont really think their is any special technique to takeing it off
Junior Member
iTrader: (1)
Joined: Apr 2003
Posts: 55
Likes: 0
From: Jacksonville, Florida
Car: 1985 Pontiac Trans Am
Engine: 6.6 Liter 406 c.i.
Transmission: T-56 6 Speed/ McLeod Street Twin
Axle/Gears: 3.42 9 Bolt Posi w/ girdle
It's actually held on by 4 little 10mm nuts and bolts that hold it to the fender. If you have a trans am you're going to have to unbolt the body kit and the body kit support brackets too.
Thread Starter
Member
iTrader: (4)
Joined: Oct 2006
Posts: 304
Likes: 0
Car: 1989 Trans Am
Engine: 5.0 TPI
Transmission: 5 Speed Manual
Axle/Gears: Stock Rear End
yea i knew there was more to it then the litte rivet things.... the only ones i found were underneath where the bumper comes up to the body. one last thing... do u have to take the black metal piece off that is attached to the bumper as well as the fender bolts?
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
