GTA Emblem Placement Templates...
#1
Supreme Member
Thread Starter
Join Date: Dec 2000
Location: Springfield, MO, USA
Posts: 1,536
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Trans Am, 1991 Firebird
Engine: 355 TPI, 3.1L V6
Transmission: 700R4 in both
GTA Emblem Placement Templates...
Does anyone know where I can get a set of templates so I install my GTA Emblems in the correct places on the panels? I have heard there's a couple places that have them but I can't find any. I need the templates for all the emblems... nose, fenders, and sail panels.
Thanks in advance!
Thanks in advance!
#2
Supreme Member
iTrader: (3)
Join Date: Jan 2001
Location: Conroe, TX
Posts: 3,158
Received 54 Likes
on
40 Posts
Car: 1987 GTA
Engine: LS1
Transmission: 4L60e
Re: GTA Emblem Placement Templates...
not sure why you'd want to put GTA emblems on either of the cars in your sig...but your best resource for these things is the gtasourcepage (http://www.gtasourcepage.com) . They have some measurements from different areas of the car. I used them and mine turned out well.
#3
Supreme Member
Thread Starter
Join Date: Dec 2000
Location: Springfield, MO, USA
Posts: 1,536
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1986 Trans Am, 1991 Firebird
Engine: 355 TPI, 3.1L V6
Transmission: 700R4 in both
Re: GTA Emblem Placement Templates...
The 91 is being converted. Hood, tail lights, and rims are already on the car. Spoiler is in the living room waiting to be painted and the I just got the emblems and am ready to install those.
The pic below is from after I had gotten the hood done at the end of last year. I wish it would have been sunny that day instead of cloudy. The shot would have looked much better. I still have the old rims in that pic. I'm waiting until it's finished before I snap anymore shots.
I checked out the GTA source page. I found the measurements for the front fender emblems but I couldn't find the measurements for the sail panel emblems.
Anyone else know where I could get the sail panel measurements?
Thanks!
The pic below is from after I had gotten the hood done at the end of last year. I wish it would have been sunny that day instead of cloudy. The shot would have looked much better. I still have the old rims in that pic. I'm waiting until it's finished before I snap anymore shots.
I checked out the GTA source page. I found the measurements for the front fender emblems but I couldn't find the measurements for the sail panel emblems.
Anyone else know where I could get the sail panel measurements?
Thanks!
Thread
Thread Starter
Forum
Replies
Last Post
2012sergen11
Engine/Drivetrain/Suspension Wanted
6
10-13-2015 07:38 PM