Need tips on straightening door panel plastic garish molding?
Thread Starter
Junior Member
Joined: Feb 2001
Posts: 56
Likes: 0
From: Tyrone, PA
Need tips on straightening door panel plastic garish molding?
The long black plastic garnish moldings at the top of my door panels are warped and bend upward looking really bad, does anyone have ideas how to straighten them out?
I took and clamped a long board to the insde of garnish molding and clamped them down to my coffe table to straighten them and heated them with a heat gun, but they did not straighten out. I suspect either I didn't heat them up enough, or need to put more of a reverse flex bend to them to get them to take shape.
Anybody know anything about this or how to go about straightening them out?
------------------
I took and clamped a long board to the insde of garnish molding and clamped them down to my coffe table to straighten them and heated them with a heat gun, but they did not straighten out. I suspect either I didn't heat them up enough, or need to put more of a reverse flex bend to them to get them to take shape.
Anybody know anything about this or how to go about straightening them out?
------------------
Moderator
Joined: Jun 2000
Posts: 8,459
Likes: 215
From: Florida
Car: 87 IROC-Z, 82 Pace Car
when you find out, let me know. Otherwise, I'm just gonna replace mine.
------------------
87 IROC 350 TPI with less than 10k original miles
www.users.uswest.net/~smoyer/iroc.htm
------------------
87 IROC 350 TPI with less than 10k original miles
www.users.uswest.net/~smoyer/iroc.htm
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
IROCZDAVE (88-L98)
Interior Parts for Sale
4
Oct 6, 2016 09:08 AM
IROCZDAVE (88-L98)
Interior Parts for Sale
1
Sep 13, 2015 09:07 PM
