where can i find IROC body parts?
Thread Starter
Banned
Joined: Oct 1999
Posts: 1,147
Likes: 0
From: avondale, az
Car: 86 IROC-Z
Engine: 406
Transmission: 700R4
where can i find IROC body parts?
well first off let me say that im am serious and i hope u can take me serious here as well. Im looking, well i should say... im hoping, i can find some actual IROC body parts. and as in IROC i mean the actual race car, not just the IROC that came off the factory floor. I tried IROC.com, but all it is is a forum. and i cant find any other web sites. I am starting autoX once the car gets out of the shop and id prefer the car to loose the excess weight. if anyone can point me in the right direction on where to get body panels and/or web addy's to someone that sales them id realy appreciate it.
AZIROC
AZIROC
Senior Member

Joined: Oct 1999
Posts: 762
Likes: 5
From: Brooklyn, NY, USA
Car: Trans Am
Engine: 350
Transmission: 700R4
Well, do a search on this board for: fiberglass by author Nightcruzer. On a couple of posts I listed all the places that sell fiberglass replacement parts, including a 1 piece front end that replaces your hood, fenders, and nose.
Thread Starter
Banned
Joined: Oct 1999
Posts: 1,147
Likes: 0
From: avondale, az
Car: 86 IROC-Z
Engine: 406
Transmission: 700R4
ok thanxs. but anyone know if/where i could find actual panels used in IROC *even though they would be about 14 years old* also, how much weight will be saved from got to all fiberglass panels?
Most of those original pieces are either destroyed or locked in Andretti's garage (the Andretti family buys and collects raced cars- been to one of their garages
)You will most likely have to find a very reputable fiberglass/plastics body shop and take digital pictures for them. You can then put pics on a grid-get exact dimensions and they can mold pieces for you. This will be very costly-but if that's what you want... If you can find someone who has these pieces laying around, let me know; but that will probably be when hell freezes over
)You will most likely have to find a very reputable fiberglass/plastics body shop and take digital pictures for them. You can then put pics on a grid-get exact dimensions and they can mold pieces for you. This will be very costly-but if that's what you want... If you can find someone who has these pieces laying around, let me know; but that will probably be when hell freezes over
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
mustangman65_79
Body
3
Aug 11, 2015 03:17 PM





